Lexmark E260d -- Redrive Assembly Access

For the reason why this post exists, see this post.

- - -

To access the redrive assembly for replacement, proceed as follows:

1) Cartridge

2) Tray 1

3) Left Side Cover
- One M3x6mm bright washerhead screw at front by Tray 1 cavity.
- One M3x6mm bright washerhead screw at rear underside.
- Two claws at underside.
- Tip out the bottom and lift to remove.

4) Right Side Cover
- One M3x6mm bright washerhead screw at front by Tray 1 cavity.
- One M3x6mm bright washerhead screw at centre underside.
- One claw at rear underside.
- One claw at front just above the screw location.
- Tip out the bottom and lift to remove.

5) Back Door
- Open door and tug forcefully to pop it off its hinge pins.

6) Back Cover
- Two M4x8mm bright washerhead threading screws.
- One claw high up at either side.
- Tip away the top and lift the cover off two hook points at the bottom.

7) Top Cover
- Four M3x6mm bright washerhead screws, two at either side.
- Lift the cover off.

8) Redrive Assembly
- Narrow Media Sensor cable connection at J11.
- Duplex Solenoid cable connection at J10.
- Two M3x8mm bright washerhead screws high up.
- Four remaining M3x6mm bright washerhead screws.

# # #

FEEDBACK

# # #