HP LaserJet 2300 -- Add-On Tray Pickup Roller Access

Pickup Roller P/N is RB2-6304.

The roller is accessed from below. There are two plastic covers concealing the roller's swing-latch bearings. For a 500-sheet tray, proceed as follows (250-sheet is similar):

1) Tray Unit less tray upside down.

2) Front Sheet Metal Cross-Member
- Two M4x10mm bright washerhead threading screws.

3) Left Side Bearing Cover
- One claw at inboard rear corner.

4) Right Side Bearing Cover
- One claw at inboard centre.

5) Left Side Bearing
- Unlatch and remove it.

6) Right Side Bearing
- Unlatch and slide it rightward over the shaft.

Here's a view of the roller ready to be removed.

Don't forget to transfer the two slip rollers over to the new pickup roller.

# # #

FEEDBACK

# # #