HP LaserJet 2200 -- Fuser Access

Fuser P/N is RG5-5559. Proceed as follows:

1) Cartridge

2) Tray 2

3) Interface Connections Cover
- Press two latch buttons at the cover's rear. The cover can then be swung away and removed.

4) Right Side Cover
- Under the cartridge door, there's a rectangular latch button. Push that down far enough and the cover can be slid forward about 5/16" to free it. There's a small claw at the front just inside the Tray 2 cavity that you may need to pry loose.

5) Rear Cover/Door
- Open the rear door part way. There's a pivoting guide rib array inside that can be unhooked to permit the door to drop open all the way.
- Two M4x10mm pan head threading screws.
- Two claws just inside the Tray 2 cavity.

6) Duplex Infeed Guide
- Two M4x14mm YZD pan head threading screws w/captive washers.
- Two small, outward-gripping claws, left and right sides.
- NOTE the three round nubs at the inner bottom of the part. Those must engage first at re-installation, then the part can be tipped back into place.

7) Fuser
- Three cable connections.
- One M4x10mm pan head threading screw.
- One M3x6mm pan head screw w/captive star washer.

# # #

FEEDBACK

# # #