Monday, November 21, 2011

Genicom 3860 -- Cover Removal

Proceed as follows:

1) Ribbon Cartridge Access Cover
- Tip it up and lift it off its hinge pins.

2) Upper Rear Cover
- Tip it back and disengage the two restraint straps from their studs.
- Lift it off its hinges.

3) Main Cover
- Two M4x16mm pan head screws w/flanged spacers (i.e. the upper rear cover restraint strap studs.)
- Two ground wire spade terminals.
- Two claws at front under the ledge.
- Two claws behind where the screws w/flanged spacers were.
- Lift the cover partway off.
- One cable connection at control panel.
- Lift the cover completely off.

4) Lower Left Side Cover
- Two claws underneath.
- One claw at upper front.

5) Lower Right Side Cover
- Same as previous.

# # #


# # #

No comments:

Post a Comment