1) Cartridge
2) Paper Tray
3) Rear Cover
> Four M3x10mm bright washerhead threading screws. Two of them are very low down in deep wells.
> Tug the cover rearward to remove it.
> MIND the parallel connector's bails when reinstalling this cover.
4) Right Side Cover (Optional. It's not necessary to remove this cover, but with it removed, the machine won't rock when it's laid on its right side.)
> Tug the cover forcefully rearward to remove it.
5) Left Side Cover
> Disconnect the speaker.
> Tug the cover forcefully rearward to remove it.
6) Drivetrain Assembly
> NOTE the green ground wire at the upper centre screw.
> Six M3x10mm bright washerhead threading screws.
> One cable connection.
7) Electronics Pan
> Four cable connections in view at the rear.
> Two M3x10mm bright washerhead threading screws at the rear. NOTE the black ground wire at the left side screw.
> Lay the machine on its right side.
> Ten M3x10mm bright washerhead threading screws from underneath. NOTE that two of the screws are accessed through 10mm diameter holes in the pan.
> CAUTION: Two of the following seven cable connections can be transposed. They're the two smallest two-conductor connections -- CN4 and CN6. You may want to mark one of them to preclude transposing them.
> Seven cable connections.
8) Gear Support Plate at Front Left
> Three M3x10mm bright washerhead threading screws.
9) Pickup Clutch
> Pull it straight off. NOTE that it's indexed to go on only one way.
10) Pickup Roller w/Shaft
> The left side bearing has a claw. Release the claw and the bearing can be slid rightward, enabling removal of the item.
# # #
No comments:
Post a Comment