HP LJ P3005 -- Fuser Access

When a P3005 needs a fuser, it's likely to need a set of four associated gears as well. See this post for information on the gear kit.

The P3005's fuser is pretty easy to deal with. Proceed as follows:

1) Cartridge

2) Tray 2

3) Rear Door Fully Open
- Tug it open forcefully and it will open all the way.

4) Rear Cover w/Door
- Two M4x10mm pan head threading screws.
- A claw at either side of the Tray 2 cavity. Raise the small door across the rear of the tray cavity to see them.

5) Mains Receptacle Bezel

6) Duplexer Input Guide (The black plastic 'ramp' at the rear.)
- Two claws -- they have ‘handles’ extending rearward.
- Push up on the claw handles and pull the guide toward you.


7) Fuser Power Cable
- Disconnect it and free it from its restraint.

8) Exit Sensor Cable (Violet)

9) Thermistor Cable (Yellow and white.)
- Free the cable from its white restraint. The restraint can be unlatched with a fingernail or a small screwdriver.

10) Fuser
- Three prominent M4x10mm pan head threading screws.
- One M3x6mm pan head screw w/captive star washer. It’s in a recess at the fuser’s lower right.
- Tug on the fuser's cables to dislodge it.

# # #

FEEDBACK

# # #